CDL Pre-Trip Inspection — Step-by-Step Practice Questions

When meeting an oncoming vehicle at night with headlights that are blinding you, look slightly down and to the right, toward the right edge of the road or the right shoulder line. This protects your night vision from the direct glare and lets you use the road edge as your steering reference until the vehicle passes. Staring directly at oncoming headlights causes temporary blindness that can last several seconds after the vehicle passes, which is plenty of time to drift out of your lane. Flashing your high beams to retaliate blinds the oncoming driver and creates real danger for both of you. Closing one eye is a partial trick used historically, but is unreliable and not recommended. Keep both eyes open and use the right edge as a guide.

A road is most slippery during the first few minutes of rain after a long dry spell. Oil, rubber, and other contaminants build up on the road surface during dry weather. When water first hits, it mixes with these substances to form a slick, almost greasy film. Once the road has been thoroughly washed by sustained rain, the contaminants are flushed off and traction improves somewhat, though wet pavement is still less grippy than dry. This is why crashes spike in the first 15 to 30 minutes of a rainstorm and why experienced drivers slow down immediately when rain starts rather than waiting for the road to look wet. Bridges and overpasses freeze first and stay slippery longer because they lose heat from both sides.

A 'shiny' or 'wet-looking' patch of road in freezing conditions is one of the strongest visual indicators of black ice. Black ice is a thin, transparent layer of ice that takes the color of the pavement beneath it, making it appear to be wet road. It forms most easily on bridges, overpasses, and shaded sections of road, especially in the early morning before sunlight has had a chance to warm the surface. If your spray from the wheels suddenly stops in cold weather, it likely means the road has frozen and you should slow down without sudden steering or braking. Don't trust ambient temperature alone; the road surface can be below freezing even when the air is 35 degrees. Bridges freeze before the rest of the road because cold air flows under them as well as over.

On a long steep descent, choose a safe target speed and a low enough gear that the engine and any auxiliary brake (Jake brake, retarder) do most of the work holding speed. Service brakes alone overheat on long grades, leading to brake fade where the brakes become progressively less effective and can ultimately fail entirely. The rule of thumb is to select a gear lower than the gear you used to climb the hill, though modern engines often allow a slightly higher gear on the way down. Coasting in neutral on a downgrade is illegal in most states and extremely dangerous because you lose engine braking entirely and gain speed quickly. Using the parking brake to control speed will burn it up and leave you with no emergency brake. If service brakes overheat, use a runaway truck escape ramp without hesitation.

If you drift onto the shoulder, do not panic-steer back. Hold the steering wheel firmly to maintain control, ease off the accelerator, stay off the brake unless you absolutely must use it, and let the vehicle slow naturally to roughly 20 mph. When ready, check your mirrors and steer back onto the pavement at a gentle angle. Sharp steering at highway speed to climb back onto pavement causes the tires to catch the edge of the asphalt and can fling the vehicle into the opposite lane or roll it. Slamming the brakes on a mixed surface (one wheel on pavement, one on dirt) causes the vehicle to pull violently to the side with more traction. The keys are: stay calm, slow gradually, and reenter the road slowly.

If your service brakes fail on a downgrade, the priority is to bring the vehicle to a controlled stop using whatever resources remain. First, downshift to use engine braking. If your route has a runaway truck escape ramp, use it without hesitation — these are loose gravel or sand ramps engineered specifically to stop runaway commercial vehicles safely, and there is no penalty or shame in using one. If no escape ramp is available, look for an uphill grade you can use to bleed off speed, or use a long open stretch of shoulder to scrub speed against guardrails or embankments as a last resort. Setting the parking brake at full speed can lock the rear wheels and cause a jackknife. Pumping brakes might restore pressure briefly on a hydraulic system, but air brake failure is rarely restored that way. Plan for brake failure before it happens by knowing where the escape ramps are on your route.

Water should not be used on fuel, oil, grease, or electrical fires. Water on burning fuel or oil floats the burning liquid across a wider area and can splash flaming material onto the firefighter. Water on an energized electrical fire conducts current and creates a serious shock hazard. Class B fires (flammable liquids) require a foam, dry chemical, or CO2 extinguisher. Class C fires (electrical) require a non-conductive agent like CO2 or dry chemical. Most commercial vehicles carry a B:C-rated dry chemical extinguisher. Water is acceptable on Class A fires: wood, paper, fabric, and rubber. For a tire fire, water can help if you can get enough flow on it, but for a small contained fire on a paper or cloth load, water is the right call.

The first priority at an accident scene is to prevent another collision. Stop your vehicle in a safe location, activate your four-way flashers, and set out the required warning devices: three reflective triangles or three flares for the standard daytime configuration. Triangles go on the traffic side: one within 10 feet of the rear, one about 100 feet behind, and one about 200 feet behind. On divided or one-way highways, all three go behind the vehicle. Moving wrecked vehicles before assessing injuries can worsen injuries and disturb the scene before police arrive. Photos and insurance details matter, but only after the scene is safe. Calling 911 is essential, but you do that from a position of safety after warning devices are out, not by walking off into traffic.

Federal regulations set the blood alcohol concentration (BAC) limit for commercial drivers at 0.04 percent, half of the 0.08 percent limit that applies to non-commercial drivers in most states. A BAC of 0.04 or higher in a commercial vehicle is a per se violation, meaning the BAC alone proves impairment under the law. Below 0.04 but with any detectable alcohol, a driver must be removed from duty for 24 hours. Some states impose stricter limits, including zero tolerance for under-21 drivers. The lower commercial limit reflects the greater consequences of impaired commercial driving: heavier vehicles, longer stopping distances, and higher kinetic energy at any speed. Refusing a federally mandated alcohol test is treated the same as a positive test.

The average adult body metabolizes alcohol at roughly one standard drink per hour. A standard drink is 12 ounces of beer at 5 percent ABV, 5 ounces of wine at 12 percent ABV, or 1.5 ounces of distilled spirits at 40 percent ABV. There is no way to speed this up: coffee, cold showers, exercise, food, and time-of-day make no meaningful difference to the metabolism rate. This is why a driver who has had three drinks at the start of an evening might still be over the limit several hours later, especially the 0.04 commercial limit. The only safe rule is to not drink before driving a commercial vehicle and to allow ample time after drinking before any operation. Hangover impairment also remains after measurable alcohol is gone.